Disassembly For Repair - Kenwood TK-8360 Service Manual

1. Disassembly Procedure
1. When removing the cabinet, fi rst remove the two screws
from the right and left with a phillips screwdriver.
Then, hook your fi nger on the edge of the cabinet and
pull it out until it is over the chassis protrusion. Remove
the cabinet by prying the cabinet as shown below.
Cabinet
2. To remove the panel assembly, fi rst turn the transceiver
upside down.
Then, insert a fl at-head screwdriver into the holes of the
chassis and tilt it in the direction as shown by the arrow.
Holes
Panel assembly
TENTATIVE

DISASSEMBLY FOR REPAIR

TK-8360/8360H/8360H
3. Disconnect the fl at cable from connector of the panel as-
sembly.
4. The panel side of q to e is pull.
Pull in r to y tabs of the speaker holder inside panel,
and remove the speaker holder from the front panel.
5. When removing the TX-RX PCB, first remove the top
packing.
Then, remove the solder of the antenna hot pin and posi-
tive terminal of the DC cord.
Remove the 15 screws from the TX-RX PCB, power
module, and audio amp.
Positive terminal
of the DC cord
Audio amp
TX-RX PCB
(
Flat cable
Speaker holder
Antenna hot pin
Power module
Top packing
U
)
11