Technical Data - AEG L 73483 FL User Manual

24 www.aeg.com
Problem
The cycle is longer than
the time displayed.
The washing results are
not satisfactory.
You cannot set an op-
tion.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.

14. TECHNICAL DATA

Dimension
Electrical connection
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
Water supply pressure
1)
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) The appliance works correctly if the water pressure is not less than 0.05 MPa (0.5 bar). If you can not
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your
domestic cold water storage system. Make sure not to have more than a distance of 5.02 m (16.5 ft) be-
tween the appliance inlet hose and the bottom of the water storage tank.
2) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible solution
An unbalanced laundry load increases the duration time. This
is a normal behaviour of the appliance.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you
wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that you press only the wanted button(s).
Width/ Height/ Depth/
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
2)
Cotton
Maximum
600 mm/850 mm/ 522 mm/ 540 mm
230-240 V
2200 W
13 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
8 kg
A+++
1400 rpm