Operation - Makita 6922NB Instruction Manual

Shear wrench
Hide thumbs Also See for 6922NB:
Table of Contents

Advertisement

004988

OPERATION

Bolt installation
Slip the tool onto the bolt so that the inner sleeve
completely covers the bolt tip.
004989
CAUTION:
Be careful when fitting the sleeve onto the bolt tip.
Striking the tip can damage it so that it will no longer
fit inside the sleeve properly.
First tighten bolts preliminarily by using a hand
wrench and then tighten them with this tool. Use
this tool only after preliminary tightening without
starting the tightening with this tool.
Keep forward pressure on the tool while sliding it further
forward until the outer sleeve fits completely over the nut.
If the tool fails to fit completely over the nut, twist the tool
slightly right and left while pushing forward.
1. There should be
1
no gap between
the outer sleeve
and the tool.
2. Outer sleeve
3. Screw
2
3
1. Inner sleeve
1
2. Bolt tip
2
004990
Pull the switch trigger. The outer sleeve turns to begin
tightening the nut.
When the specified torque is attained, the bolt tip will be
sheared at its notched portion. The bolt tip will remain
inside the inner sleeve.
004991
Release the switch trigger and withdraw the tool in a
straight line.
004992
CAUTION:
Do not force the tool down excessively. Apply the
downward force to the degree just needed to hold
the tool firm.
Pull the tip ejector (tip lever) to eject the bolt tip from the
tool. Catch the sheared bolt tips to prevent them from
falling dangerously below. Keep the tips off of the ground,
floor, walkways, etc. to prevent injury from tripping or
falling.
5
1. Outer sleeve
1
2. Nut
2
1. Notched portion
1
2. Bolt tip
2
1. Outer sleeve
1

Advertisement

Table of Contents
loading

Table of Contents