Deactivation Character
This sets the character used to terminate scanning when using Character Deactivation Mode. On the
Chart (Code Page
1252), page A-3, find the hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
ASCII character. Scan
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the picture is taken. Use these codes to set the
time between when the trigger is pulled and when the picture is taken. During the delay time, the aiming light will appear, but
the LEDs won't turn on until the delay time is over. Default = Off.
200 milliseconds
* Off (no delay)
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning
digits (0 - 4,000 ms) from the
Aimer Mode
This feature allows you to turn the aimer on and off. When the Interlaced bar code is scanned, the aimer is interlaced with the
illumination LEDs. Default = Interlaced.
Off
Programming Chart
Save
to finish.
Deactivation Character
Programming Chart
to read the alphanumeric combination that represents that
inside the back cover of this manual, then scan Save.
Delay Duration
ASCII Conversion
400 milliseconds
* Interlaced
3 - 13