Cisco Business 350 Series Manual page 3

Configure stack settings through the command line interface (cli)

Hide thumbs Also See for Business 350 Series:

Step 2

Connect one end of the Small Form-Factor Pluggable (SFP) cable that came with your device into

the SFP+, XG3, or XG4 port of your switch.

In this example, the cable is connected to XG3 port of the switch.

Step 3

Connect the other end of the SFP+ cable into the SFP+, XG3 or XG4 port of your switch.

In this example, the cable is connected to XG4 port of the switch.

Step 4

Repeat Steps 2 to 3 to the remaining switches.

In this scenario, two switches are being configured for stacking and the SFP cables are connected

to ports 3 and 4 on both switches.