Husqvarna LF 75 Operator's Manual page 12

2. Set the throttle control to ⅓ throttle.
3. Set the choke control in the correct position.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
4. Set the engine ON/OFF switch to "ON".
5. Pull the starter rope handle slowly until you feel
resistance.
6. Release the starter rope handle to let the starter
rope go back.
7. Pull the starter rope handle until the engine starts.
945 - 003 - 03.04.2020
8. Open the choke control gradually until it is fully open.
9. Let the engine operate at idle speed for 2–3 minutes.
10. Set the throttle control to full throttle.
To stop the product
1. Move the throttle control to the idle speed position.
2. Set the ON/OFF switch to "OFF". The engine stops.
3. Move the fuel valve to the "OFF" position.
To start the product (Hatz)
1. Set the throttle control (A) to half throttle.
A
11