Advertisement
MLS Digital Luminaire Controllers: MLS2000DIS / MLS2000DIW for DSI ballasts
Only suitably qualified personnel should install this equipment.
Electrical Connections
750mm
lead
32.5mm
Mounting Details
C L
Installation
Snap-in to infill panel (max 0.7mm/ 22 SWG) or use any combination of fixing holes on rear. Use only No 4
type B º inch self-tapping screws. Ensure that projection of screws into pilot holes does not exceed 4.5mm.
The recommended position for the detector is in the middle of the luminaire. Where this is not possible and the
detector is fitted near one end of the lamps, please ensure that the detector is at the 'cold' end of the lamps.
In order to achieve satisfactory light-level regulating operation, a detector must observe a substantially greater
proportion of artificial light from the luminaire(s) under its control than from neighbouring luminaires not under its
control. This is particularly important when planning the installed layout of linear luminaires that have an
integral detector positioned at one end.
To Test with HC5 or HC6
Once the MLS Digital Luminaire Controllers have been installed within the luminaires, the HC5 or HC6 may be
used to switch luminaires ON and OFF. Luminaires with regulating ballasts will also dim and brighten.
MLS2000DALIS / MLS2000DALIW for DALI ballasts
Red
- Live
Blue
- Neutral
Yellow
Polarity-free
Green
digital output
White - MLS Bus +ve
Black - MLS Bus -ve
26mm
6.5mm
43.5mm sq
50mm sq
Cable entry point
C L
Connection to ballast only.
Do not connect to other detectors.
Advertisement
