Table of Contents
Advertisement
76 XTR MANUAL.qxd
4/17/03
4:58 PM
Page 8
Installation
CB Antenna
CB Antenna
Installation
Do not remove foil covering from bottom
of magnetic base. The foil protects the car finish.
Note
Mobile installations (cars, trucks,
boats, etc) should be made only
with a non-directional antenna
system.
A standard antenna connector
(Type SO-239) is provided on the
Connector Box for easy
connection to a standard PL-
Installation Instructions
259 cable termination.
This magnetic mount antenna has
been tested to withstand normal high
speed driving. The magnet will hold
securely under the following
conditions. Always make sure the antenna base is on a
clean, flat, painted or unpainted surface. The magnetic
base will not hold on non-metallic or aluminum
surfaces. Periodically clean all parts of antenna to
maintain maximum performance.
Clean dust and dirt away from area where antenna will
be placed.
Place antenna on vehicle, roof, trunk lid, or any flat
surface. For best results centrally locate.
Run coax cable thru to inside of vehicle routed in a
manner where it will not interfere with the driver or
controls and connect to the antenna connector of the
radio.
8
External Speaker Installation
Mount external speaker in desired location.
Plug jack into the back of the Connector Box
labeled EXT.
*The external speaker should have 4-8 ohms
impedance and be able to handle at least 4 watts.
Installation
External
Speaker
Installation
Note
Internal speaker is muted when
external speaker is connected.
9
Advertisement
Table of Contents
