Advertisement
--
Unscrew the tht~e bolts of the support on the mounting plate.
The three nuts at the rear of this plate are crimped on.
-
Unscrew the fOl.I r bolts securi ng the motor to its support.
Pullout
the pir securing the p{ni~n on the motor shaft (pin dia.
mm).
3
Replace the motlr and proceed vice versa.
Unscrew the support from the wiring plate.
Rep
1
ace the hea,1:er a nd proceed vice versa.
Remove the two :iecuri n g rings and then pu
from the switch eyelet.
Press the lever into upright position.
Remove the two ruts securing the switch to its support.
-
After·replacing
Reset the axle and the two bushes in the eyelet and fit the two
securing rings.
-
the switch, tighten the two nuts on the support.
..
..
,,,",,,
,
11
out the small ax
1
e
Advertisement
