Advertisement
Remove the two bolt5 which hold the angle support on the forward
main mounting
plat'E~. These bolts can be seen on the plate;
corresponding
nuts behind the plate ~re crimped in position.
-
Take out the complEte assem6ly, i.e., angle support and opening
release(s).
-
Disconnect
the leads and remove the faulty opening release.
-
After rep
1
acement
assembly
work.
adjustments
are requi red as preci se assembly is ensured
mounting
system.
b) Shunt closing
rele~ie(3.0.36) (fig. 84)
-
Remove the plate which may be fitted on the angle support.
-
Remove the two bolts which hold the angle support on the forward
main mounting
plate; the corresponding
Cr-;il1F.d ~;!-position.
-
Disconnect
the leads and remove the faulty closing release.
-
After replacement
assembly work.
-
Mount the angle sUl=port on the forward main mounting
two bo
1
ts incorrect
and the-ram
of the coil should be 2 mm.
-
Press the ram manuilly and check, that in final position
shaft (3.0.33) the closing pawl (3.0.43) moves.
(If the open ing release, wi re up and comp
Af:er
replacement
(If the c
1
os ing release, wi re up and complete
pos ition. The c
1
of
the
angle
support,
nuts behind the plate are
-
earanee between
the
the
1
ete
no
by the
plate with
1
ever
of the
Advertisement
