Commands-Quick Reference - Honeywell HPB User Manual

HPB\HPA User Manual
•
FORMAT PRESSURE READINGS—Changes data length into host processor
Binary Format Commands
P3
P4
OP
ASCII Format Commands
OP
•
START-UP PARAMETERS—Sets the HPB configuration after power is applied
WE
SP
MO
•
PRESSURE NOISE REDUCTION—Reduces pressure noise signals
DS
•
DIAGNOSTIC AND RESET CONTROL
IN
RS
CK
OP
•
USER AND STARTUP MESSAGES
A=
B=
C=
D=
MO
•
HPB UNIT INFORMATION
P=
S=
V=
ID
M=
•
CUSTOMIZE PRESSURE WINDOW
F=
X=
Z=
3 COMMANDS—QUICK REFERENCE
www.honeywell.com
Single RS-232 pressure...binary format
Continuous RS-232 pressure...binary format
Set operating mode...binary format checksum...set signed or extended binary output format
All readings, except P3 and P4, are ASCII format readings.
Set operating mode...all readings or only changed readings
Enable parameter writes to the RAM or EEPROM
Store RAM parameters to the EEPROM for startup
Specify the power-up message and operating mode
Set deadband and sensitivity parameters
Performs a software reset of microprocessor
Read status of error indicators
Performs and provides the result of EEPROM checksum
Use pressure reading checksum for binary format
Store 8 characters of user supplied data
Store 8 characters of user supplied data
Store 8 characters of user supplied data, which can be configured as a watchdog or reset
message
Store 8 characters of user supplied data, which can be configured as a watchdog or reset message
Specify the startup header selection
HPB production date
HPB serial number
HPB software version number
Assign device ID and group addresses
Read the maximum full scale pressure limit allowed
Customize the full scale pressure limit
Set the slope ―m‖ parameter for user input mx+b control
Set the offset ―b‖ parameter for user input mx+b control
11