Insert Batteries; Before Installation; Scope Of Delivery; Assemble Device - AEG CTV 3202 LCD Instruction Manual

English
26

3.2 Insert Batteries

• Open the battery compartment at the rear.
• Insert 2 x 1.5 V batteries type R03/AAA. Observe correct polarity (see battery compartment)!
• Close the battery compartment again.
During longer periods of non-use remove the batteries to avoid battery leakage.
WARNING:
• Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
• Keep batteries away from children. They are no toys.
• Do not force batteries open.
• Avoid contact with metal objects (rings, mails, screws, etc.), risk of short circuit!
• Short-circuited batteries can heat up and even ignite, risk of burns.
• For your own safety cover battery terminals with sticky tape during transport.
• In case of battery leakage avoid contact with eyes and mucous membranes. After contact wash your hands, rinse
eyes with clear water and contact physician with persistent troubles.
CAUTION:
• Do not use odd battery types or fresh and exhausted batteries.
• Do not dispose of batteries with the household trash. Return exhausted batteries to collection points or your dealer.
NOTE:
• If the remote control range shortens the batteries are exhausted and must be replaced.
• Do not use rechargeable batteries.
• Protect batteries from heat and direct sunlight. Do not dispose of batteries by burning, danger of explosion!
• Remove exhausted batteries from the device. Remove the batteries during longer periods of non-use to avoid
battery leakage.
• Wash thoroughly after coming into contact with battery acid.

4. Before Installation

4.1 Scope of Delivery

After unpacking ensure that the following parts were included:
• TV set
• Stand and fastening ring (screwed onto the thread socket of the television, where applicable)
• Equipment connection cable
• Remote control (incl. 2 x 1.5 V batteries type LR03 AAA)
• User manual

4.2 Assemble Device

• For protection of the device, place a blanket onto a sturdy table that can support the weight of the television.
• Carefully place the screen of the television onto the blanket.
• Remove the fastening ring from the thread socket on the television, if applicable.
• Slide the stand onto the threat socket on the television. The stand can only be attached in one direction. Please
observe the guide rails on the socket.
• Tighten the fastening ring by hand to fix the stand.
• Remove the protective film from remote control and TV set, if attached.
• Place the TV set on a stable, level surface. Ensure that the surface can carry the TV's weight.
• Protect the device from extreme heat and humidity.
• Ensure sufficient ventilation on all sides. When placed in a wall unit leave at least 20 cm on top and 10 cm distance at
the sides for ventilation.