AEG SLS 4705 Instruction Manual & Guarantee page 39

Connecting the Transmitter
Transmitter
• Connect the 3.5 mm jack plug to the AUDIO IN socket
on the transmitter.
• Then connect the cinch plugs to the AUDIO OUTPUT
SUR RIGHT/LEFT of the subwoofer.
Note: It is possible to connect the front loudspeakers
instead. In this case connect the cinch plugs to the
AUDIO OUTPUT FRONT RIGHT/LEFT connections.
• Insert the power pack into the 5V DC connection
provided and then into a correctly installed 230V/50Hz
power socket.
Connecting the Receiver
Receiver
• Connect the surround or front loudspeakers to the R
OUT / L OUT (right/left) of the receiver.
• Insert the mains lead into a nearby socket and switch
the receiver on.
Note: With the VOLUME control (11) you can individually
adjust the volume of the loudspeakers connected to the
receiver.
05-SLS 4705 AEG neu2 39
Channel Adjustment
• Press the FREQUENCY SELECT button on the bot-
tom of the transmitter. Then please press the SCAN
button on the receiver.
• When the SCAN button is pressed again the next
channel is selected.
• Changing the channel setting may also be necessary
in cases where reception is not perfect.
Rectifying Faults
No Audio Transmission
• Has the mains adapter/mains lead being inserted?
Check the connection on both the transmitter and the
receiver.
• Is the receiver switched on? Turn the receiver on with
the mains switch located on the rear of the device.
• Is the transmission source switched on?
• Walls and ceilings reduce the range.
• Check the connections on the connected devices.
• Check whether the signal source (e.g. DVD player) is
set to surround playback.
Poor Reception Quality
• Turn the transmitter and receiver again so that they
face one another.
• Change the position of the transmitter and receiver a
little.
• Poor reception may result from interference from
other radio-transmitting devices such as cordless or
mobile telephones or CB radio.
Remote Control
Note: The lithium cell in the battery compartment of the
remote control has been secured for transport with a foil.
This prolongs the lifetime of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
Inserting the Batteries
The battery of the remote control is a long-life lithium cell.
If the range of the remote control is reduced during use,
please proceed as follows:
• Open the battery compartment on the back of the
remote control.
• Replace the cell by a battery of the same type. Ensu-
re correct polarity.
• Then close the battery lid.
Warning: batteries are not to be disposed of together
with domestic wastes. Dispose of the used batteries at
the relevant collection bin or at your dealer's.
Never throw batteries into the fi re.
When the remote control is used, care should be taken
that there are no objects between the remote control and
the central loudspeaker. (e.g. table, chair, etc.). These
objects prevent the infrared beam of the remote control
from reaching the receiver of the central loudspeaker. It is
then not possible to control the television with the remote
control.
39
14.02.2006, 9:02:36 Uhr