Table of Contents
Advertisement
5
Adjustment > Adjustment (Reader) > Measurement during Reader Controller PCB Replacement and After RAM Clear:
Adjustment (Reader)
Service mode backup
The machine is adjusted one by one at the factory shipment and the adjustment values are
written on the service label.
When the adjustment is carried out at a field and the service mode values are changed, be
sure to write the changed values on the service label.
If there is no corresponding items on the service label, write the value to a blank field.
The service label is affixed to the back of the Reader Front Cover.
In addition, backup and restoration in service mode is also possible. It takes approx. 10
seconds to execute this backup.
• Backup
Lv.
COPIER > FUNCTION > SYSTEM >
2
RSRAMBUP
• Restoration
Lv.
COPIER > FUNCTION > SYSTEM >
2
RSRAMRES
NOTE:
When changing the service mode setting values, it is recommended to back them up in
the above service mode. Performing backup makes the work easier when replacing the
Reader Controller PCB, etc.
5
Adjustment > Adjustment (Reader) > Measurement during Reader Controller PCB Replacement and After RAM Clear:
T-5-1
T-5-2
Measurement during Reader Controller PCB
Replacement and After RAM Clear:
Points to note before replacing the Reader Controller PCB:
• Be sure to output the latest P-PRINT.
(Lv.1) COPIER > FUNCTION > MISC-P > P-PRINT
• Back up the service mode setting values related to Reader Controller. (Excluding the
case where service mode cannot be executed due to the Reader Controller PCB not
operating normally)
(Lv.2) COPIER > FUNCTION > SYSTEM > RSRAMBUP
1) Using SST, download the newest system software (R-CON).:
2) Perform RAM clear.
Lv.
COPIER > FUNCTION > CLEAR >
1
R-CON
3) Turn the connecting equipment OFF/ON.
When backup is performed normally
4) Restore the backup data.
Lv.
COPIER > FUNCTION > SYSTEM >
2
RSRAMRES
NOTE:
Work is completed when backup was normally performed.
5-2
T-5-3
T-5-4
5-2
Advertisement
Table of Contents
