Advertisement
MODULE FOR SINGLE LAMP SELECTION AND MONITORING
Switching of one selected light in the electric circuit
Indicator LED
Rotary coding switch
for setting the exact lamp adress
DIP-switch 1
ON for non-maintained mode (Default)
Function
By means of a suitable control, it is possible with the aid of the SET010 select to determine whether the
lamp connected to it is ready for use or faulty.
Settings
Setting the lighting address is carried out by a rotary coding switch that is easily accessible from the
outside.
Lighting addresses 1 to 16 can be slected when DIP switch 2 is set at OFF.
The module is already prepared for administering a total of 32 lighting addresses.
The address range 17 to 32 can be selected by setting DIP switch 2 to ON.
(DIP switch 2 = ON and rotary coding switch = 1 is equivalent to lighting address 17 etc.)
Technical description
Dimensions (L x W x H in mm)
Temperature:
Cross section:
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
SET010 select
DIP-switch 2
OFF for lighting address 1-16 (Default)
ON for lighting address 17-32
Connect L and N correctly!
Exchanging L and N causes malfunction.
SET010 select
78 x 30 x 20
-30°C up to +60°C, T
=+75°C
cmax
2
Max: 1.5mm
Attention!
GB
Prewired
DIP-switch 3 (OFF)
http://www.hls-nordic.com
Advertisement
