Returning To A Pre-Marked Position - Canon Elura Elura Instruction Manual

Returning to a Pre-Marked Position

E
Use the wireless controller to go back to a pre-determined point on a tape
following playback.
1. Press the ZERO SET MEMORY button during playback at a point
you want to return to later.
• The time code is replaced by a tape counter that is set to zero with the Â
indication.
• Press the ZERO SET MEMORY button once more to cancel the zero set
memory.
2. When you have finished playback, fast forward or rewind the tape.
The tape stops automatically when it reaches the zero set position.
• RTN1 or `RTN appears in the display.
• The tape counter with  indication disappears from the display and the time
code reappears.
Notes:
• The zero set memory may not function correctly where there is a break between
recordings on the tape.
• You can also use zero set memory to mark a position on a tape in record pause
mode. When you then play back the tape, pressing rewind will take you back to
the pre-marked position.
• If you remove the tape while the zero set memory is set, the memory is
canceled and the tape counter reverts to timecode.
• The camera remembers your setting even if you turn it off and back on again or
move the program selector.
66
V C R •
O F F •
MOVIE •
PAUSE
P.SCAN •
PHOTO •
ZERO SET
MEMORY
AUDIO
INSERT
REC
SEARCH
SELECT
FF
REW PLAY
– / STOP + /
DUB.
A/V
PAUSE SLOW 2