36 Mechanical installation
Installation procedure
Direct wall mounting
1. Mark the locations for the four holes. The mounting points are shown in
Dimension
drawings.
2. Fix the screws or bolts to the marked locations.
3. Position the drive onto the screws on the wall. Note: Only lift the drive by its
chassis.
4. Tighten the screws.
DIN rail mounting (Frames A and B only)
1. Click the drive to the rail as shown in Figure a below. To detach the drive, press
the release lever on top of the drive as shown in Figure b.
2. Fasten the lower edge of the drive to the mounting base through the two fastening
points.
a
Mains choke installation
See the chapter
Mains chokes
EMC filter installation
See the chapter
EMC filters
1
2
on page 95.
on page 99.
b