Buffalo WBR-B11 Quick Setup Manual page 3

Wireless cable/dsl router-b

Hide thumbs Also See for WBR-B11:

Step 2 - Connecting Cables to the AirStation

Carefully following the instructions for connecting cables to your AirStation is

key to a quick and simple initial setup. Please pay attention to the order and

port in which cables are attached to ensure proper communications between

your computer, the AirStation, and the internet connection.

1. Power down the cable or DSL modem and the computer which will be used to

conﬁ gure the AirStation router.

2. Plug the cable or DSL's LAN Ethernet cable into the AirStation's WAN port.

Initially, you may need to unplug this cable from your computer, hub or other router.

3. Plug the provided Ethernet cable into a LAN port on the AirStation and plug the

other end into your computer's Ethernet adapter's (NIC) port. If you plan to initially

conﬁ gure the AirStation wirelessly (not recommended), you may skip this step.

4. Power on your cable or DSL modem and wait one full minute, power on the

AirStation router, wait one full minute, and then power on the computer which

will be used to conﬁ gure the AirStation. If the red DIAG light on the AirStation is

lit or ﬂ ashing after several minutes of being powered on, please consult Buffalo

Technology Technical Support.