Makita FN001G Instruction Manual page 9

2. Set a nail strip so that the nail tips touch the bot-
tom of the magazine and slide the nail strip toward the
driver guide.
3
► 1 . Nails 2. Slide door 3. Driver guide
3. Return the slide door to the original position until
the lock lever locks it.
To remove the nails, press the lock lever and slide the
slide door. Take out nails from the magazine.
Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When firing nails on the material with easily-marred
surfaces, use the nose adapter. Put the adapter onto
the pointed end of the driver guide.
You can store the nose adapter in the holder at the back
end of the magazine to keep it from being lost.
3
1
► 1 . Nose adapter 2. Driver guide 3. Holder
Hook
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
for their intended purposes only. Using for unin-
tended purpose may cause accident or personal
injury.
waist belt. Dropping the nailer, which is caused by
1 2
the hook accidentally coming out of place, may cause
unintentional firing and result in personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
2
3
► 1 . Groove 2. Hook 3. Screw
1
9 ENGLISH
CAUTION:
When installing the hook, always
CAUTION:
Use the hanging/mounting parts
CAUTION:
Do not hang the hook from the
1
2