Pair Up With The Subwoofer; Automatic Pairing; Manual Pairing; Basic Operation - Motorola amphisoundX MT250-ASB31 User Manual

7. Pair up with the
subwoofer

Automatic pairing

7.1
Plug the soundbar and the subwoofer
into the mains sockets and then press
on the unit or remote control to switch
the unit to ON mode. The subwoofer and
soundbar will automatically pair.
• When the subwoofer is pairing with
the main unit, the Pair Indicator will
flash fast.
• When the subwoofer is paired with
the main unit, the Pair Indicator will
light up.
NOTE:
- Do not press the Pair button on the
subwoofer, except for manual pairing.
- If the automatic pairing fails, pair
the subwoofer with the main unit
manually.

Manual pairing

7.2
If no audio from the wireless subwoofer
can be heard, manually pair up the
subwoofer.
1 Unplug both units from the mains
sockets again, then plug them in
again after 3 minutes.
Press and hold the PAIR button on
-
the subwoofer for a few seconds.
- The Pair indicator on the subwoofer
will rapidly blink.
2 Then press the
remote control to switch the unit ON.
3 L i g h t s t o p s b l i n k i n g o n c e t h e
S u b w o o f e r i s p a i r e d w i t h t h e
Soundbar.
4 I f t h e P a i r i n d i c a t o r s t i l l k e e p s
blinking, repeat step 1-3.
NOTE:
• The subwoofer should be within 6m
of the soundbar in an open area (the
closer the better).
• Remove any objects between the
subwoofer and the soundbar.
on the unit or
• If the wireless connection fails again,
check if there is a conflict or strong
interference (e. g. interference from
an electronic device) around the
location. Remove these conflicts or
strong interferences and repeat the
above procedures.
• If the main unit is not connected with
the subwoofer and it is in ON mode,
the unit's POWER indicator will flash.

8. Basic Operation

Standby/ON

8.1
When you first connect the main unit to
the mains socket, the main unit will be in
Standby mode.
• Press the button on the unit or on
the remote control to switch the unit
ON.
• Press the
the unit back to STANDBY mode.
• Disconnect the mains plug from the
mains socket if you want to switch
the unit OFF completely.
- If a TV or an external device is
connected, the unit will switch on
automatically when the TV or the
external device is switched on.

Automatic Power Off Function

8.2
The unit automatically turns to Standby
mode after about 15 minutes if the TV
or the external unit is disconnected,
switched off or the volume is too close to
mute.
• To switch the unit off completely,
remove the mains plug from the
mains socket.
• Please turn the unit off completely to
save energy when not in use.

Select Modes

8.3
Press the (SOURCE) button on the unit
or the AUX, BT, OPT/COA, HDMI 1/2, HDMI
ARC and USB and buttons on the remote
control to select the desired mode. The
selected mode will show on the display.
button again to switch
11