Cleaning Under The Belt Cover - Toro 22282 Series Operator's Manual

screwdriver shank clamped horizontally in a vise
(Figure 26).
Figure 26
Note:
You can also check the balance using a
commercially manufactured blade balancer.
2. If either end of the blade rotates downward, file
that end (not the cutting edge or the end near
the cutting edge) until neither end of the blade
drops.
Installing the Blade
1. Install a sharp, balanced Toro blade, the
accelerator, the lock washer, and the blade bolt.
The sail of the blade must point toward the top
of the mower housing for proper installation.
Note:
Torque the blade bolt to 82 N∙m (60 ft-lb).
WARNING
Operating the machine without the
accelerator in place can cause the
blade to flex, bend, or break, resulting
in serious injury or death to you or to
bystanders.
Do not operate the machine without the
accelerator in place.
2. Return the machine to the operating position.
Cleaning under the Belt
Cover
Service Interval: Every 50 hours—Remove grass
1. Shut off the machine and wait for all moving
parts to stop.
g002280
2. Remove the battery pack; refer to
Battery Pack from the Machine (page
3. Remove the belt cover
mower housing.
1. Belt cover
4. Lift off the cover and brush out all the debris
around the belt area.
5. Install the belt cover.
25
clippings and debris from under the
belt cover.
Removing the
(Figure 27) from the
Figure 27
20).
g024255