Table of Contents
Advertisement
2-1.
Operation Notes
2-1-1.
Flexible Board
• Make sure that the conductive side of a flexible board does not have any stain or foreign materials.
• Do not touch the conductive side of flexible boards with bare hands.
• Plug in a flexible board straight, fully into the connector until it reaches the end inside.
OK
(The flexible board was plugged in
straight and completely)
Flexible
Board
Reference line
Connector
Connector
• When opening the connector's holder in direction A, do not open it with excessive force.
Holder
A
Connector
A
• When closing the connector's holder, press it evenly while pushing a flexible board in direction B.
Holder
Connector
Flexible Board
B
Insulation side
• Make sure that the flat cable and flexible board are not cracked or bent at the contact end.
• Do not apply excessive force to the gilded flexible board.
2-1-2.
Discharging of the Flash Capacitor
The charging capacitor for the flash has been charged at high voltage. Therefore, there is a possibility of an electric
shock if you directly handle this capacitor.
The high-voltage charge will not be discharged by simply turning off the unit's power. Make sure any remaining voltage
is discharged by short-circuiting the flash capacitor with a Short Jig.
DSC-HX350
Section 2
Service Note
(The flexible board was plugged in
crooked.)
Flexible
Flexible
Board
Board
Reference line
Connector
Flexible Board
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
NG
(The flexible board was not plugged in
completely.)
Reference line
Flexible
Board
Connector
NG
Flexible
Board
Connector
Connector
2-1
Flexible
Board
Hide quick links:
Advertisement
Table of Contents
