Advertisement
Parts of the washing machine
Machine body
Lint filter box
Pulsator
Control panel
Cabinet
List of accessories
Name
Water inlet hose
assembly
Drain hose
Screw ＊
Bottom cover ＊
Operation manual
Installation manual
Warranty card
NOTE
＊ Bottom cover and Screw are applied by service staff.
Keep the Operation manual and installation manual
for future reference.
4
Top lid
Water inlet hose
connecting port
Drain hose
Power cable
Adjustable foot
Quantity
1 set
1
1
1
1
1
1
Common non-fault phenomenon (Please refer to
this section if there is an abnormality happens.)
Abnormal display
Caution
It generates a beep when washing machine indicates abnormal display.
As the phenomenon may not be a fault,
please check it again before sending the machine for repair. In the case
of failure, please consult Sharp Service Center. Be sure not to disassemble and
repair the machine without permission.
Display
Possible non-fault cause
The faucet is closed.
Low flow at the faucet.
E1
Water inlet filter net is blocked.
＊When water is not supplied enough to
operate the machine, this error code
will be displayed only after six hours.
Top lid is opened when the
reservation course starts.
E2
Top lid is not closed during spin
drying.
The drain position is relatively high.
The end of drain hose is blocked.
E3
Drain hose is folded/crumpled/tied.
Washing machine inclines or is
shaky.
E4
The clothing is lopsided.
There is a possibility
of malfunction.
C＊
＊ : number
Top lid is opened during
CHILD LOCK.
U9
19
E
Cannot spin drying.
Solution
Turn the faucet on, press START/
PAUSE key.
Increase water supply, press START/
PAUSE key.
Clean the filter net, press START/
PAUSE key.
Close top lid.
Adjust drain hose properly, press
START/PAUSE key.
Clean drain hose, press START/
PAUSE key.
Level the washing machine by
adjusting the foot.(p.18)
Distribute the clothing evenly.
Turn off the power and pull out Power
cable. After wait 1 minute,
turn on and operate.
Turn the power off, and check inside
the tub
Caution
CHILD LOCK is not released, unless
you reset it manually.
Adjust drain hose properly.(p.6)
Wait for 10 minutes, and press
START/PAUSE key.
17
Advertisement
