Mounting
The ball valve can impair the function of sprinkler systems
or similar water-based extinguishing systems.
Before mounting the module check whether an extinguishing
Caution!
system is installed or is to be installed.
►
Loosen the 2 screws M 6x15 (3)
►
on the bottom of the drive (1).
Lift the drive off the valve (2).
►
Install the ball valve at the
►
corresponding
using a suitable tool (open-
ended spanner).
Mount the device switch HS 30
►
as described in the mounting
and operating instructions of the
device switch. Ensure that the
cable has the right length!
Electrical connection
Install an all-pole switch
►
with 3 mm opening on
site in the incoming
line.
Wire the device switch
►
and
ball
accordance
adjacent diagram and
connect them to the
power supply.
If appropriate, select a different mounting site.
plumbing
valve
in
with
the
by