AEG LA 10 Operating Instructions Manual page 23

Mark air pressure
value e.g. 2 bar
5
Image 6
▪ As a guide set the arrow marker on the mano-
meter adjusting ring
5
pressure value (see Image 6).
▪ Set the On / Off switch
now operational.
▪ To activate the compressor set the compressor
On / Off switch to ( I ).
19
Note: the compressor can be switched off at
any time by setting the compressor switch
or the operating switch
▪ Once the air pressure
justing ring has been reached, switch the com-
pressor off using the compressor switch
To do so, set the compressor switch
▪ To switch off the unit the operating switch
the unit must be switched off.
▪ Open the valve quick disconnect
the auto valve connector from the tyre valve.
▪ Also check the air pressure with a second
pressure gauge to determine the accurate value.
Repeat the process if the desired air pressure
has not been reached.
▪ Then replace the valve cap on the tyre valve.
Inflating sporting goods, toys and recreational
products
Do not operate the compressor for more
than 10 minutes. After this time allow the
unit to cool down for 10 minutes!
▪ First read the product manufacturer's instruc-
tions for inflating and the approved maximum
air pressure before inflating the product.
to the desired air
to ( I ). The unit is
13
19
to ( O ).
13
marked on the ad-
5
.
19
to ( O ).
19
on
13
and remove
4
▪ Open the product's valve cover.
▪ Using the valve quick disconnect
correct valve adapter and press it into the item's
valve. If the valve adapter detaches from the
valve whilst inflating, use your hand to press it
into the valve whilst inflating.
▪ Verify the valve adapter is securely connected to
the valve by carefully pulling on it.
▪ As a guide, set the arrow on the manometer
adjusting ring to the desired air pressure
5
value.
▪ Set the operating switch
now operational.
▪ To activate the compressor set the compressor
switch on the compressor to ( I ).
19
Note: the compressor can be switched off at any
time by setting the compressor switch
operating switch to ( O ).
13
▪ Observe and check the firmness of the item
whilst inflating. If the item has already been
overinflated, immediately interrupt the process
and switch the compressor off!
Attention! Excessive air pressure may
cause the item to burst! Risk of personal
injury and property damage!
▪ Once the air pressure marking on the adjusting
ring has been reached, use the compressor
5
switch to power the compressor off.
19
▪ Remove the valve adapter from the item's valve
and close the item's valve cap.
Non-binding pressure guidelines
Automotive tyre approx. 1.9 – 3.5 bar
Trailer tyre approx. 2.4 – 3.4 bar
Motorcycle tyre approx. 1.7 – 2.9 bar
Bicycle tyre approx. 2.0 – 4.0 bar
Football approx. 0.6 – 1.1 bar
Volleyball approx. 0.18 – 0.22 bar
Attention! Please note the manufacturer
specifications for the item. Do not use the
compressor to inflate swimming aids!
GB 23
secure the
4
to ( I ). The unit is
13
or the
19