Replacing The Light Bulb - Baumatic TITAN1 Instruction Manual

o Remove the drawers and shelves from the freezer section and
leave the door to the freezer compartment open. You can place a
bowl of warm water inside the freezer compartment to speed up
the defrost process.
o You can use a sponge to mop up the defrost water that will run
into the bottom of the freezer section.
o IMPORTANT: You should place some old towels on the flooring
that is immediately in front of the appliance. In case any defrost
water comes out of the freezer section and onto the floor.
o Once all the ice that has built up has melted, then the inside of
the freezer compartment should be dried thoroughly. Failure to
do this will result in immediate ice build when the appliance is
turned back on.
o With dry hands, reconnect your appliance to your mains supply.
You should select the coldest freezer setting (number 5) for a 24
hour period, before returning it to the normal temperature
setting of number 3.
o You should not attempt to freeze fresh food inside the freezer
compartment until this 24 hour time period has elapsed.
o Do not defrost the appliance with other electrical devices
(e.g. hair dryer). Do not use sharp metal objects to
remove the ice on the freezer, as this could cause damage
to the refrigerant system.

Replacing the light bulb

WARNING: PLEASE ENSURE THAT YOUR
APPLIANCE IS DISCONNECTED FROM
YOUR MAINS SUPPLY BEFORE
ATTEMPTING TO REPLACE THE LIGHT
BULB.
Fridge section
The light bulbs can be found behind the light cover at the top of the
fridge section (below the control panel).
1) Remove the screws that hold the light
cover in place.
19