Operation; Power Supply - AEG ETV DVD 4549 LCD Instruction Manual

English
44
Insert Batteries into the Remote
Control/replace
A. Alternating Current Adapter

Operation

WARNING:
Leaking battery acid may cause a health hazard. Remove batteries from
the remote control when depleted or the unit is not in use for an extended
period of time. Clean up any leakage with a cloth immediately. In the event
of skin contact, rinse the afected area immediately. In case of ingestion
consult a physician immediately. In the event of eye contact, rinse eyes and
consult a physician immediately.
CAUTION:
Upon disposal, adhere to the recycle and environmental regulations of
your respective country. Never throw batteries into open fire.
NOTE:
■
The lithium cell in the battery compartment of the remote has
been protected with plastic foil for transport. This extends the
lifetime of the battery. Before initial use, please remove this foil
to prepare the remote control for use.
■
The life span of enclosed batteries may be reduced due to storage.
1. Open the battery compartment on the bottom of the remote
control.
2. Replace the cell with a battery of the same type (CR 2025). Pay
attention to the polarity.
3. Close the battery compartment again.
NOTE:
The signals of the remote control are transmitted to the DVD-Player by
infrared light. Ensure that the DVD-Player is not exposed to direct sun-
light. This may render the signal transmittal from the remote control
to the DVD-Player impossible.
Remote Control Range
To use the remote control point it toward the remote control sensor
located at the front of the unit. The distance between remote control
and sensor should not exceed 5 meters. The angle of the remote
control to the sensor should not exceed 30 degrees within right, left,
above and below.

Power Supply

The alternating current adapter is functional with an alternating cur-
rent of 100 V and 240 V but:
■
The enclosed mains cable may only be connected to a power
source of 230-240V alternating current within Europe.
■
To connect to an alternating current source outside of Europe a
plug adapter compatible with the respective outlet must be used.