Advertisement
Available languages
Available languages
Damage
Unpacking
Assembly
Head-rest mounting
If the unit is damaged:
■
To avoid endangerment in the event the network connector is
damaged only the manufacturer or their customer service may
replace the part.
■
If moisture penetrated the unit or the unit has been dropped or
has been damaged otherwise, an authorized specialized dealer
must evaluate the damage. Disconnect the unit and contact an
authorized dealer.
Assembly and Connection
Please unpack the unit and all accessories and check the contents for
completeness.
CAUTION:
Always transport/ship the unit in the original packing to avoid
damages. Retain the original packing materials for this purpose.
Recycle useless packing material in accordance with your countries
regulations.
NOTE:
Damages due to transport must be reported to the supplier im-
mediately.
1. Fold out the stand at the rear of the DVD Monitor.
2. Place the unit on a stable, level and lat surface. Maintain a dis-
tance of a minimum of 10 cm from walls and other objects.
3. Connect the unit to an outlet installed according to regulations.
4. Remove protective cover from device / TFT Screen if applicable.
You need three fixing belts for the installation.
WARNING:
The fixing belts are not suitable for use while driving. Risk of injuries!
NOTE:
The supplied fixing belts are only intended for use while the vehicle
is parked.
1. Thread one fixing belt through the side brackets of the unit
(Fig. 1/19, 2/15).
2. Fix the device now horizontally to the back of the head-rest.
3. Fasten the horizontal fixing belt together with the other two fixing
belts. Tie them vertically around the head-rest.
English
43
Advertisement
Chapters
