Table of Contents
Advertisement
IndraControl VAC 08.1 CDI+ Splitter
SEL
MOD
0
1
1
1
0
Open or 0 V
1
24 V
Tab. 12-1: The operation modes are selected using the inputs "SEL" and "MOD"
12.2 Display elements
There are five LEDs on the CDI+ splitter (see
CDI+ splitter" on page
LED
Vin
Video1
Link1
Video2
Link2
Tab. 12-2: LEDs at the CDI+ splitter
12.3 Operating and error display
Start the measures specified in the following table if one of the LEDs is on.
LED
Name
V
LED is on
IN
LED is off
Video1
LED flashing
green
LED off
Link1
LED green
LED red
LED green
and red
LED off
Operator display 1 (XCDI+tx1)
Active
-
12). The LEDs indicate the current operating state.
Description
Display of the 24 V voltage supply
Operating state, operator display 1
Operating state, operator display 2
Description
Normal mode
24 V DC missing
Image data is sent to the operator
display 1.
The PC does not sent any image data
to the CDI+ splitter
Communication active und operator
panel selected.
Operator panel not selected and no
communication possible with the op-
erator panel
Operator panel not selected, but the
communication is possible with the
operator panel
No communication possible with the
operator display, even though it is ac-
tive (selected via SEL or MOD)
Device description
Operator display 2 (XCDI+tx1)
Active
-
fig. 9-1 "Connector panel of the
Action
-
Check the cable of the voltage supply
which is connected to X1S1.
-
-
-
-
-
-
R911400465_Edition 01 Bosch Rexroth AG
25/33
Advertisement
Table of Contents
