Installation Precautions - Panasonic CZ-RTC3 Installation Instructions Manual

Installation Precautions

Installation location
Floor
Remote control wiring
 Wiring diagram
Indoor unit
R1
R2
RC wiring (fi eld supply)
• No polarity
Terminals for RC wiring
 Type of wiring
 Use cables of 0.5 to 1.25 mm
 Total wire length: 500 m or less
(The wire length between indoor units
should be 200 m or less.)
 Number of connectable units
Remote controller: Max. 2
Indoor unit: Max. 8
6
(EN)
5 mm or more
50 mm or
more
1 to 1.5 m
.
2
 Install at the height of 1 to 1.5 m from
the fl oor (Location where average
room temperature can be detected).
 Install vertically against the fl oor.
 When installing more than 1 remote
controller next to each other, keep
distance of 5 mm on the right and left
and 50 mm on top and bottom.
 Avoid the following locations for
installation.
• By the window, etc. exposed to
direct sunlight or direct air
• In the shadow or backside of objects
deviated from the room airfl ow.
• Location where condensation
occurs (The remote controller is not
moisture proof or drip proof.)
• Location near heat source
• Uneven surface
 Keep distance of 1 m or more from
the TV, radio and PC. (Cause of fuzzy
images or noise)
Attention
RC
 Be careful not to connect cables
1
to other terminals of indoor
2
units (e.g. power source wiring
terminal). Malfunction may occur.
 Do not bundle together with the
power source wiring or store in
the same metal tube. Operation
error may occur.
 If noise is induced to the unit
power supply, attach a noise fi lter.