Table of Contents
Advertisement
Installation Precautions
Installation Location for the Receiver
The wireless remote controllers use a very weak infrared light for its signal, which can result in the
signal not being received because of the following infl uences, so take care in where the unit is installed.
• Inverter or rapid-start type fl uorescent lights (Models without glow lamps)
• Plasma display or LCD televisions
• Direct sunlight or other sources of bright light
Mounting
Installing the Receiver
The receiver can be installed only on the
corner shown in Fig. A. Consider the direction
where the panel is attached to the indoor unit.
1
Remove the air inlet grille
Indoor unit electric component box
2
Remove the corner cover.
Remove the screw fi xing the corner
cover.
Place a hand on both the right and left
convex parts of the corner cover to
remove it.
Ceiling panel
4
(EN)
Installation position for receiver
(Fig. A)
Indoor unit electric
component box
Air Inlet grille
Corner cover
Convex part
Screw
Corner cover
3
Wire the receiver.
Hang the string of the receiver on the pin
of the ceiling panel.
String
Pass the wiring from the wireless
receiver section into the slit.
(See "Wiring for the Receiver")
Fix the wiring with the clamper (supplied)
while leaving enough length of wiring to
remove the receiver.
• When attaching the fi lter chamber, cut
the clamper (a), and attach the receiver.
(a) Cut this clamper.
Fix with the clamper (supplied).
4
Fix the receiver.
Fit the receiver to the ceiling panel so
the 5 claws are properly set, and fi x it
with the removed screw.
• Make sure the wire
is not caught.
• Refer to the
installation
instructions
supplied with the
panel.
Pin
Receiver
Slit
Advertisement
Table of Contents
