Removal Of The Electrical Box - Hitachi RCI Service Manual

10 Servicing

10.2.5 Removal of the electrical box

Nº
1 Electrical box set screw
2 Drainage pump connector (PCN6)
3 Automatic louver connector (CN17)
4 Outlet thermistor (THM2)
5 Automatic louver electrical box set screw (THM2)
6 Fan motor connector (CN203)
7 Fan motor connector (CN201)
Remove the air inlet grille as indicated in chapters
air filter, see on page 277 and
on page 277.
Remove the electrical box as follows:
1 Remove the electrical box cover.
2 Disconnect the thermistors (THM2), the drainage motor
connector (PCN6), the float switch connector (CN14), the
automatic louver connector (CN17) and the fan motor
connector (PCN203, CN201) from the PCB.
3 Remove the three set screws from the electrical box and
remove carefully.
279
SMGB0063 rev. 1 - 10/2010
Part
Removal of the
Removal of the air inlet grille, see
10