Panasonic FV-0511VH1 Operating And Installation Instructions page 11

INSTALLATION ( NEW CONSTRUCTION ) CONTINUED
STEP 10 (Perform as needed)
Remove the grille blade holder to adjust
orientation of the grille blades to adjust the
direction of warm air flow. (Fig. 8)
IMPORTANT:
Align the arrow marks on the grille blades with
the desired air direction. (The warm air flow
comes out in the direction of the arrow marks.)
Air
direction
(Factory setting)
STEP 11
Reinstall the grille blade after adjusting the
grille blades.
STEP 12
CAUTION
Before turning on the light, ensure that
the connector is in the correct position.
The connector must snap completely
into place.
Mount grille carefully so that lead wire
is not pinched.
NOTICE
Pay attention to the orientation of the
grille and the mounting springs.
The grille will only fit to the ceiling in
the proper orientation. (Fig.9)
On the side with the wiring, insert the mounting
spring into the respective slot and connect the
plug to the housing of the lighting unit*. (Fig.10)
FV-0511VHL1 only
*
STEP 13
Adjust Pick-A-Flow™ switch. Refer to
FEATURES on page 6. (Fig.10)
STEP 14
Insert the other mounting spring into the
respective slot as shown and mount the grille
to the fan body. (Fig.11)
Air
direction
Tapping screw
( 4X12)
1
Grille
Grille blade
holder
Heater
Correct
Heater
Incorrect
Pick-A-Flow™ switch
Plug connector
Mounting spring
Grille
Gloves
Grille blades
(
Left figure shows
factory setting.
Grille
3
Attach the grille blades
to the grille with the arrow
mark on the blade in front.
Mounting
Spring
Grille
Mounting
Spring
Grille
Ceiling drywall
Mounting
spring
Lighting unit
Fig.10
Ceiling drywall
Slot
Fig.11
Fig.10
English
2
)
Fig.8
Fig.9
11