Table of Contents
Advertisement
5
Installation Of Appliance
Remove the appliance from its packaging.
Install the plastic flue flaps provided in the
accessories to the air outlet flue of the appli-
ance as shown below.
1. Flap Pin Socket
2. Flap Pin
• Insert the plastic pin (Figure 8 / area no.
2) on the pin socket on the motor exhaust
(Figure 8 / area no.1). Then bend the flap
lightly to insert the other pin on the flap and
insert the other pin to its socket (Figure 8).
A
B
A
B
(Figure 9)
• By using the 4 x 40 screws provided with
the hood, install the appliance to the cabi-
net from the points A, B, C and D. When the
slider set moves, the front panel shall not
rub on the cabinet door (Figure 9)
Cooker Hood / User Manual
C
D
C
D
(Figure 10)
• Install flexible aluminium pipe to plastic flue
outlet. Install the other end of the pipe to
the flue hole on the wall (Figure 10).
5.4 Connecting to Flue
If you are going to use the Ø 120/150 mm
plastic flue adapter, connect one end of the
pipe to this adapter, if you are not going to
use it, to the direct output on the product.
Connect the other end of the pipe to your
flue. Check that these two connections are
tight enough so they will not come out when
the appliance runs on full power. Ensure that
the flaps inside the flue work when tightened
with clamp. Connect the flue connection duct
outside the adapter. If the connection duct
is fitted inside the adapter, the covers that
prevent air return shall remain closed and air
won' t be sucked in. The length of the pipe
connection as well as the number of elbows
must be as minimum as possible.
Suitable
A : Flue exit pipe
B : Non return flaps
C: Plastic Flue
The valves are closed then the appliance is
not operating and prevent possible outside
odour and dust from entering inside.
Not suitable
13 / EN
Advertisement
Table of Contents
