Heat Sink - HP ENVY x360 15m Maintenance And Service Manual

3. Remove the graphics fan (3).
Reverse this procedure to install the graphics fan.

Heat sink

To remove the heat sink, use these procedures and illustrations.
Table 5-10 Heat sink descriptions and part numbers
Description
Heat sink (includes replacement thermal material)
Before removing the heat sink, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the heat sink:
1. In the order indicated on the heat sink, remove the four Phillips M2.0 × 3.2 screws (1) that secure the heat
sink to the system board.
2. Swing the front edge of the heat sink (2) up until it rests at an angle.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 29).
29).
Battery on page 31).
Spare part number
M45485-001