Removal And Replacement Procedures For Authorized Service Provider Parts; Component Replacement Procedures; Preparation For Disassembly; Bottom Cover - HP ENVY x360 15m Maintenance And Service Manual

5 Removal and replacement procedures for
authorized service provider parts
This chapter provides removal and replacement procedures for authorized service provider parts.
IMPORTANT:
Accessing these parts can damage the computer or void the warranty.
NOTE: Details about your computer, including model, serial number, product key, and length of warranty, are
on the service tag at the bottom of your computer.

Component replacement procedures

To remove and replace computer components, use these procedures.
NOTE: HP continually improves and changes product parts. For complete and current information about
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
You must remove, replace, or loosen as many as 51 screws when you service the parts described in this chapter.
Make special note of each screw size and location during removal and replacement.

Preparation for disassembly

To remove and replace computer components, use these procedures.
See Removal and replacement procedures preliminary requirements on page 19
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.

Bottom cover

To remove the bottom cover, use this procedure and illustration.
Table 5-1 Bottom cover description and part number
Description
Bottom cover
Components described in this chapter should be accessed only by an authorized service provider.

Removal and replacement procedures for authorized service provider parts

for initial safety procedures.
Spare part number
M45483-001
29