Buffalo UBSAFE GHT Series Manual

__ __ __ __ __ __ __ __ GHT-__ __ __ __ __ __
(record your personal 3-8 digit security code)
COMPLETE & SUBMIT REGISTRATION CARD TO VERIFY OWNERSHIP
KEEP THIS MANUAL AND SALES RECEIPT FOR FUTURE REFERENCE
If you experience a problem or have questions, visit
Service at 1-888-287-6981, Monday-Friday, 8 AM - 4 PM Central Time. A copy of the
sales receipt is required.
Install (4) 1.5V battery, located in the front protective Styrofoam (See BATTERY INSTALLATION)
To open an electronic lock the first time, press the following numbers/symbols on the electronic keypad
User code: Factory set
(These numbers are preset. You should change the entry code as soon as possible after opening the
safe to insure proper security.)
After you have entered the factory code, you will need to turn the handle counter clockwise to open
the door. You will have 5 seconds to turn the handle before the locking mechanism is reactivated. When
the valid code entered, the lock will beep twice and the green LED turns on. When an invalid code
entered three times, the lock will have long beep-beep, the yellow LED turns on and the safe is locked for
20 seconds. Wrong entry for 3 more times will lock the safe for 5 minutes.
ENTERING YOUR SECURITY CODE
CHANGING USER CODE #1
1) Keep door open. Press the RED "reset" button, the yellow LED turns on.
2) Enter 3-8 digit code, then press "A". Two Beeps and yellow light turns off confirm success.
3) Test the lock operation several times BEFORE closing the door.
CHANGING USER CODE #2
1) Keep door open. Press "0 0" and yellow light flashes twice.
2) Press the RED "reset" button, the yellow LED turns on.
3) Enter 3-8 digit code, then press "B". Two Beeps and yellow light turns off confirm success.
DO NOT SHUT THE DOOR UNTIL YOU HAVE CONFIRMED THAT THE NEW SECURITY CODE HAS
BEEN ENTERED CORRECTLY.
*WRONG TRY PENALTY --- Entry of three (3) consecutive invalid codes starts a 20 second lock out.
(During lock out, the key pad will not respond to any operation.) If entry of three more consecutive invalid
codes again, the key pad will not respond to any operation 5 minute.
If the code fails, follow steps 1 and 2 again. If the code works successfully, record your combination
number on the front of this form or somewhere in your records, then you should lock the safe.
1. 2. 3. 4. B
Secondary User code: Factory set
ALWAYS PERFORM THE OPERATION WITH THE DOOR OPEN
ALWAYS PERFORM THE OPERATION WITH THE DOOR OPEN
UBSAFE MANUAL
(Serial number)
http://www.buffalotools.com or call Customer
1. 2. 3. 4. 5. 6. B