Advertisement
856-129899-202-00
(4) Memory board installation procedure
a. The memory board has cutouts to prevent incorrect insertion. Please orient the board so
that the connector polarity and board cutouts match. (See the following figure)
b. Insert the board vertically on the connector. Press the levers at each end of the connector
so that they fasten the half-circle shaped cutouts on each edge of the board. (See the
following figure)
(5) Continue to install or remove internal optional devices, mount and connect the server, and
turn it on.
(6) Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, refer to Chapter 3 (2.BIOS Setup Utility) for BIOS Setup Utility in
"User's Guide".
(7) Run BIOS Setup Utility, and select Memory Configuration and then Memory Information
from the Advanced menu. Make sure the capacity of added DIMM is displayed properly.
Refer to Chapter 3 (2.BIOS Setup Utility) for BIOS Setup Utility in "User's Guide".
(8) Select Memory Configuration from the Advanced menu, and then specify Yes for Memory
Retest.
After that, select Save Changes and Exit to reboot.
Advertisement
