Advertisement
NEC Installation
______ Secure all of the connector screws.
System 4xi xi xi xi xi - NEC MT Series Projector Connections
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
__________ System 4 xi channel numbers correspond to the projector's "Group" numbers.
Extron • System 4 xi xi xi xi xi Switcher Series • User's Manual • P/N 68-413-02 Rev. E
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
(shown as CC 50') into the PJ Comm port on the System 4xi. The other end has
a 9-pin female connector. Plug this into the other 9-pin male D connector on the
NEC COM adapter.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV
cable onto the System 4xi output and those on the other end onto the matching
BNCs on the NEC connector panel. See cable diagram.
8. Power up the projector and set the projector as follows:
• if your system has less than 10 inputs, set the projector to SW_Level 1 mode
• if your system has 10 or more inputs, set the projector to SW_Level 2 mode
9. Apply AC power to the System 4xi.
Use the diagram below as a guide when connecting the System 4xi to the NEC
MT Series Projector. Refer to NEC documentation to continue the installation.
NEC-LCD
Adapter
26-458-01
9-Pin Male
9-Pin Female
INPUT 1
INPUT 2
H/HV
V
H/HV
V
AUDIO
AUDIO
R/C
G/Y
B
R/C
G/Y
B
Connecting the System 4 xi xi xi xi xi to the NEC MT-1000 Projector
System 4 xi . See page 2-5 for cabling guidelines.
Configuration and Connections
15-Pin Male
15-Pin
Male
INPUT 3
INPUT 4
PJ COMM
H/HV
V
H/HV
V
AUDIO
AUDIO
RS 232
R/C
G/Y
B
R/C
G/Y
B
SY-VGA
26-173-01
RGBHV 5 BNC
OUTPUT
H/HV
V
AUDIO
R/C
G/Y
B
Page 8
Advertisement
