NWZ-S763/S763BT/S764/S764BT/S765
2-3.
OPEN THE SHORT-LAND
Note 1: This illustration sees the mechanical commonness block from LCD assy side (lower half).
Note 2: Make sure to remove one solder to become an open state before disassembling the mechanical commonness block.
Note 3: Solder the short-land after all wirings are connected when you exchanged some mounted board.
2-4.
CAP
– Front bottom view –
2 Push the part A.
A
8
1 Remove the solder of short-land.
4 Remove the claw after moving the
cap in the direction of the arrow C.
1 screw
(M1.4
2.5)
3 Move the panel (rear) assy in the
direction of the arrow B a little.
5 cap
C
4 Remove the claw after moving the
cap in the direction of the arrow C.
1 screw
B
(M1.4
2.5)
Note: When installing the cap, take
care not to crush two claws.