Table of Contents
Advertisement
5019_102_00273_INSTAL_GB
Installation instructions
PLEASE NOTE: Your model of
Installation is similar for all models either Single or Double. Information referring to Single models only is in
italic. Installation diagrams have been simplified to enable clearer instruction. FOR INTEGRATED
PRODUCTS FOLLOW THE INTEGRATED PANEL PREPARATION INSTRUCTIONS P/N 526610,
BEFORE MOVING THE PRODUCT INTO THE CAVITY.
READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY.
Step 1: moving the product into the cavity
WARNING!
Be careful of sharp edges.
Important!
DO NOT push middle of drawers.
MOUNTING TAB OPTIONS
The mounting tabs are in pairs, one on each side of the product.
They are used to secure the product to the cavity sides. Installation
requires two sets of tab pairs be used, either A and B tab pairs or B
and C tab pairs. All tabs would be optimum.
1 If the top installation tabs C are to be used, fit to the chassis by
inserting into the top slots as shown. Ensure the tabs are fully
locked in place.
2 Check cavity for any obstructions that may interfere with sliding
the product back. Loosen the feet DOUBLE MODELS ONLY.
3 Push product into cavity to suit adjacent cabinetry. Do not push
middle of drawer(s). Ensure inlet, drain hose(s) and power supply
cord are not restricted or damaged by carefully pulling all excess
length through the services hole, while the product is being
pushed back into the cavity.
FOR SINGLE MODELS, check that the base of the product is not
bowed. Do not rest single models on your knee when moving them
into the cavity.
30-05-2007
13:25
Pagina 14
may differ from the model shown in the installation diagrams.
R
14
1
2
3
Advertisement
Table of Contents
