Advertisement
3.1 Rear Panel Connections
Power socket
Power switch
CONNECTOR
DC
RJ-11 RS232 port
PS/2 keypad port
3.2 The Front Panel Push-Button
Push the power switch to ON. The buttons on the front panel light up when the statement printer is
receiving power. The following table describes push-button's LED status and functions.
If the printer prints continuously for two minutes, you must stop printing
LED
PRINTER
STATUS
MODE
All Button
Off
LEDs Off
ZyAIR SP-200
Figure 2 Statement Printer Rear Panel
Table 1 Rear Panel Connections
Use the printer's included power adaptor to connect this power socket to a
power supply.
Use a printer cable to connect this port to the gateway.
Connect an optional PS/2 keypad to this port. Refer to the gateway User's
Guide for information on how to configure the gateway for use with the SP-
200 and the optional PS/2 keypad.
for at least eight minutes.
Table 2 Front Panel Push-Buttons
All of the printer's functions are stopped.
Hold button A down while you turn on the power to have the printer
print a self-test.
DESCRIPTION
FUNCTION
2
PS/2 keyboard port
RJ-11 RS232 port
Advertisement
