Advertisement
Mounting Options
NOTE: Before mounting permanently,
conduct a Sensor Walk Test (see the
controller's instructions) to verify
adequate signal strength and adjust the
device location and orientation as
necessary.
The PROINDMV can be mounted on the
wall or in corners:
[A] = Wall Mounting Holes
•
[B] = Corner Mounting Holes
•
The rear tamper plate MUST be
•
mounted to a stud, sold wood, or
with a robust wall anchor.
NOTE: Do not aim detector at windows,
especially those that let in direct sunlight,
or at heat sources such as fireplaces,
radiators and heating vents.
Detection Patterns
Enrolling the Detector
1.
Use AlarmNet 360 to program (www.alarmnet360.com)
2.
When prompted, insert the batteries or, if powered, open and close again.
3.
LED flashes rapidly at power up.
After enrolling, verify adequate signal strength by conducting a sensor test (see the controller's instructions) with the device in its
intended mounting location. Adjust the device location and orientation as necessary.
Advertisement
