Honeywell CN100 Planning And Installation Manual page 47

LED Condition
ETH2 ETH2 (FTEB) link is Good
ETH2 (FTEB) link is Down (FTE B cable
disconnected)
IOL IOLink is Good
IOLink is Down
RS485 NA
PWR All power rails on the board are Good
STATUS CN100 is running in primary or non-
redundant role
CN100 is running in primary or non-
redundant role, soft failure conditions
exists
CN100 is running in secondary role
CN100 is running in secondary role, soft
failure conditions exists
CN100 is powering up
CN100 is starting up or is running
recovery firmware
CTRL CEE is enabled and active (RUN)
CEE is enabled and inactive (IDLE)
CN100 or CEE is not loaded (NODB)
CEE is disabled
Chapter 6 - Diagnostics and Troubleshooting
LED
Color
Status
- Green
- Red
- Green
- Red
- -
- Green
Solid Green
Blinking Green
Solid Orange
Blinking Orange
Solid Red
Blinking Red
- Green
- Orange
- Red
- Off
Note
Bi-color
LED
Bi-color
LED
Not
Supported
Single
color LED
Tri-color
LED
Tri-color
LED
47