Installing 918-4 Roll Groover On 1224 Threading Machine - RIDGID 918 Series Operator's Manual

918 Roll Groover
NOTE! Support legs are not needed when when using
these stands.
Drive bar must be centered in front chuck
WARNING
jaws. All bolts must be tight and the drive bar must be
securely held in chuck when closed.
Front Chuck
Carriage
Foot Switch
Figure 4 – 918 Roll Groover Mounted on 1822 with 1406
Stand
Installing the 918-4 Roll Groover on the
1224 Threading Machine
Sub-Assembly
1. Align housing plate in recessed area of 1224.
2. Align 918 on the 1224 mounting base. (Figure 5)
3. Install and tighten the (2)
connect the 918 to mounting base.
4. Attach pump bracket with the two (2)
bolts.
5. Position hydraulic pump and securely bolt in place
" x " hex bolts.
with (4) 1 / 3 /
4 4
6. Attach drive bar adapter to roll groover by tightening
(2) set screws.
1.800.561.8187
6
918-2
Sub-assembly
Drive Bar
Support
Support
Leg
" x 1 " hex bolts which
1 / 1 /
2 4
" x
3 /
8
www.
Hydraulic Pump
" x " bolts (4)
1 / 3 /
4 4
for mounting
hydraulic pump
Figure 5 – 918 Heavy Duty Roll Groover on 1224
Threading Machine Mounting Base
Installing on 1224 Threading Machine
Leg
1. Position carriage towards front chuck and swing car-
riage tools to rear position.
1406
Stand
CAUTION
prevent accidental contact.
2. Place 918-4 on the far side carriage rail and lower
onto near side rail. (Figure 6)
3. Position base so that the drive bar feeds into the
open chuck.
4. Tighten chuck jaws securely into drive bar.
WARNING
jaws. All bolts must be tight and the drive bar must be se-
curely held in chuck.
" hex
1 /
2
Ridge Tool Company
.com
" x 1
1 /
2
for mounting base
Position reamer inside the die head to
Drive bar must be centered in front chuck
information@itm.com
1224
Mounting
Base
Housing
Plate
" bolts (2)
1 /
4