Solutions To Remote Control Problems; Solutions When A Battery Message Appears - Epson LightScene EV-110 User Manual

Solutions to Remote Control Problems

If the projector does not respond to remote control commands, try the following solutions:
• Check that the remote control batteries are installed correctly and have power. If necessary, replace
the batteries.
• Make sure you are operating the remote control within the reception angle and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to enter sleep mode. Release
the button to wake the remote control up.
• Strong fluorescent lighting, direct sunlight, or infrared device signals may be interfering with the
projector's remote receivers. Dim the lights or move the projector away from the sun or interfering
equipment.
• If available, turn on the remote receiver in the projector's menu system, or check if the remote receiver
was turned off.
• If the remote receiver setting is off, press and hold the Menu button on the remote for at least 15
seconds to restore the default setting.
• If you assigned an ID number to the remote control to operate multiple projectors, you may need to
check or change the ID setting (feature not available with all projectors). If you press ID > 0 on the
remote it should communicate with all projectors.
• If you lose the remote control, you can purchase another from an authorized Epson reseller.
Parent topic:
Related references
Projector Feature Settings - Settings Menu
Remote Control Operation
Related tasks
Replacing the Remote Control Batteries

Solutions When a Battery Message Appears

If you see a message telling you that the battery that saves your clock settings is running low, contact
Epson for help.
Parent topic:
Solving Projector or Remote Control Operation Problems
Solving Projector or Remote Control Operation Problems
179