Replacing Belt - Samsung SU8860 User Manual

Maintenance
POP-UP bRUSh bRUSh MAINTENANcE
The pop-up brush should be checked regularly for hair or debris wrapped around the
brush roll and shaft pulley.
Checking brush roll, shaft pulley and belt
1. Unplug cleaner from electrical outlet.
2. If a clog is present or debris is visible, turn the two fixer
covers on the back of the pop-up brush to the unlock
position to remove the brush cover and clear any
obstructions.
3. Inspect condition of brush roll and clean string, hair, and
other debris from brush roll, paying particular attention
to brush roll ends. Replace brush roll if brushes are worn
down. To remove brush roll, pull up and out of end slots in
nozzle housing. Insert ends of brush roll into same slots to
replace.
Inspect belt to ensure that it is in good condition. If,
belt is broken or cracked, replace belt according to
'Replacing Belt' instructions.
4. Unscrew the four screws on the back of the pop-up brush
to remove the bottom place and clean string, hair, and
other debris from shaft pulley and belt areas.
5. Reposition bottom plate and screws. Tighten screws
securely.
6. Insert the four tabs on edge of brush cover and snap
closed. Turn the two fixer covers to lock position.

Replacing Belt

1. Unplug cleaner from electrical outlet.
2. Remove brush cover. See figure 'Checking brush roll, shaft
pulley and belt' instructions.
3. Loop one end of new belt around shaft of pulley.
4. Loop other end of belt around designed area on brush roll.
Insert brush roll into slots in nozzle housing. See 'Checking
brush roll, shaft pulley and belt' instructions.
bottom
plate
brush
cover
shaft
pulley
shaft pulley
maintenance _19
fixer
cover