Maintenance
clEANING ThE PRE-MOTOR FIlTER
The pre-motor filters (Foam Filter, Micro Filter) protect the motor from dirt particles.
It is located in the filter case on the back of the dust bin. If the motor protection filters
become dirty, remove and clean filters according to the following instructions.
Check the pre-motor filters at least once a month and clean or replace as needed.
More frequent filter cleaning or replacement may be necessary if you are vacuuming
new carpet, fine dust, or have allergy concerns.
Follow the instructions for best vacuuming performance.
1) Remove dust bin as described in
'Empty Dust Bin' section pg.13.
2) Remove the filter case from the dust
bin. It is located on the back of the dust
bin.
3) Separate foam filter and micro filter
from filter case.
14_ maintenance
4) Wash filters and case in cold water
5) Dry for at least 24 hours.
Foam Filter
Micro Filter
Filter Case
only.
Ensure filters are completely dry
before refitting onto the vacuum
cleaner.
The pre-motor filters may be hand
washed in cold water with mild
detergent. Rinse well and air dry
throughly before re-installing.