Honeywell F58G Series Product Data page 11

REPLACING AN IONIZER WIRE.
SPRING
CONNECTORS
PRESS
DOWN
IONIZER
WIRE
1 TWO EYELETS HOLD IONIZER WIRE TO CELL.
Fig. 11. Replacing ionizer wire.
.
Fig. 12. Using ohmmeter to check
electronic cells for short circuits.
F58G,H AND F58GUV SERIES COMMERCIAL DUCT MOUNTED ELECTRONIC AIR CLEANER
IONIZER
EYELETS
WIRE
1
NEEDLENOSE
PLIERS
M1540B
COLLECTOR
TERMINAL
IONIZER
TERMINAL
COLLECTOR
TERMINAL
M6155
Replacement of UVC tube
WARNING
Breakable Glass Hazard.
Can cause personal injury.
Be careful when inserting bulb into lamp base. Wear
protective gloves when handling the bulbs.
Be careful when inserting bulb into lamp base, wear
protective gloves, long sleeve clothes and face
shield to avoid skin exposed to the UV when
handling the bulbs.
Gently hold the tube body and rotate bulb into the bulb
holding bracket, making sure that the tube base is facing
toward the lamp hold. Plug the bulb into the lamp base, pay
attention to the alignment of the localization snap joint
between the tube base and lamp holder.
Reducing Ozone Odor Modification
WARNING
Electric Shock Hazard.
Can cause personal injury.
Disconnect power before opening power supply
cover.
The electronic air cleaner generates a small amount of
ozone in normal operation. During the first week or two of
operation, the amount may be higher because of sharp
edges on some of the new high voltage metal parts. Normal
use quickly dulls these edges.
The average person can detect the odor of ozone in
concentrations as low as 0.0003 to 0.010 parts per million
(ppm). The electronic air cleaner contributes 0.005 to
0.010 ppm of ozone to the indoor air. The US Food and
Drug Administration and Health and Welfare Canada
recommend that indoor ozone concentration should not
exceed 0.050 ppm. As a comparison, the outdoor ozone
level in major cities is sometimes over 0.100 ppm.To reduce
the ozone generated by the air cleaner:
11
Fig. 13.
31-00442—01