AEG SRP 4354 BT Instruction Manual page 47

Overview of the components
1 Handle
2 TIMER button
3 SET/PAIR/ID3 button
4 /MO/ST. button
5 button (playback/pause)
6 TUN.+ button (search run forward)
7 TUN.- button (search run backward)
8 OPEN/CLOSE CD tray open/close
9 SLEEP button (sleep)
10 MEMORY button (memory)
11 EQ button (equalizer)
12 FUNCTION Function selector switch
13 FOLD./10/M- button (album / 10 tiles downwards)
14 FOLD./10/M+ button (album / 10 titles upwards)
15 STANDBY/ON button (standby/operation)
16 VOLUME regulator (volume)
17 PROG./P-MODE button
18 Headphone connection
19 USB connection
20 LCD display
21 AUX IN jack
22 Loudspeaker
23 IR sensor for the remote control
24 CD tray
25 FM telescopic antenna
26 AC~ AC connection
27 Battery compartment
28 PAIR sensor (BT display, LED)
Remote control
1 FUNCTION button
2 TIMER button
3 MO/ST. STOP button
4 B-SKIP/DOWN button
5 -MEM/FOLD./10 button (album / 10 titles downwards)
6 MEM/PROG./P-MODE button
7 MUTE (mute) button
8 VOL- (volume) button
9 VOL+ (volume) button
10 EQ button
11 ID3 button
12 MEM/FOLD./10+ button (album / 10 titles upwards)
13 F-SKIP UP button
14 /SET (playback/ pause) button
15 SLEEP button
16 POWER STANDBY button
17 Battery compartment
18 IR sensor
Installation/Introduction
• Select a suitable location for the device. Suitable loca-
tions are dry, even and anti-slip surfaces on which you
may operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the
display.
WARNING:
Turning up the volume too high may damage your hearing.
Power supply
• Make sure the grid voltage corresponds to the figures on
the rating plate.
• Connect the enclosed power cable (see battery compart-
ment, if necessary) with a properly installed protective
contact socket and the AC~ connection on the rear of
the device.
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• The preset time and radio stations are lost as soon as
the power supply is interrupted.
Battery Operation (Batteries not supplied)
• Open the lid of the battery compartment on the rear
side.
• Insert the 8 batteries type UM1/R20 1.5 V. Observe the
correct polarity (see bottom of battery compartment)!
• Close the battery compartment.
Should the device not be used for a long periods, remove
the batteries, to prevent any "leakage".
NOTE:
• If a mains cable is connected, the batteries are auto-
matically switched off.
• The preset time and radio stations are lost as soon as
you remove the batteries.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Do not dispose of batteries with your household trash.
Please hand over at authorized collection points or
return to your dealer.
WARNING:
Do not expose to intense heat, e.g. sunlight, fire etc. Dan-
ger of explosion!
Insert/Replace Battery in Remote Control
NOTE:
The batteries in the compartment of the remote control are
secured by a foil. This extends the life of the battery. Please
remove this foil before the first use to make the remote
control ready for operation.
• Open the battery compartment on the underside of the
remote.
English
47